← Back to overview · Tips & tricks
Tips & tricks
Cleaning the Aerator: A Straight Stream Again
Tap spraying or running weakly? How to unscrew the aerator, clean the screen and refit it correctly. A simple guide from your local plumber.
Cleaning the aerator: how it works
The aerator, also called a flow regulator, sits at the end of the tap spout. It mixes air into the water so the stream is soft and splashes less. Because it works like a fine screen, lime, sand and small particles from the pipe get caught in it. Typical signs: the stream sprays sideways, bubbles irregularly or gets weaker.
What you need
- A soft cloth
- Possibly pliers or the matching key (supplied with some taps)
- Vinegar or citric acid, an old toothbrush
- A small container
Step 1: Unscrew the aerator
First put a plug in the drain so that no small parts disappear. The aerator can usually be unscrewed by hand anticlockwise. If it is stuck, wrap a cloth around the housing and turn it carefully with pliers. Some models are recessed and need a special key.
Step 2: Note the parts
The housing often contains several small parts: screens, an insert and a seal. Lay them out in the order they come out, or take a photo. That way you will put everything back correctly.
Step 3: Clean and descale
Rinse out loose particles under running water. Then place the parts in diluted vinegar or citric acid for a while. Use the toothbrush to remove the remaining deposits. Clean the seal with water only.
Step 4: Refit
Put the parts back in the right order, check the seal and screw the aerator back on by hand. Do not tighten it too much, or it will be hard to loosen next time. Run the water briefly and watch for drips at the thread.
Good to know
After work on the water supply, for example in the building or in the street, more dirt can collect in the aerator. It is worth taking a look then. If the aerator is damaged or the thread is stripped, it can usually be replaced. If hardly any water flows despite a clean aerator, the cause may lie deeper. Then we can help: AQUARO Haustechnik, +41 58 510 76 24.
Checklist
- Plug the drain so nothing disappears
- Unscrew the aerator anticlockwise
- Lay out the parts in order or take a photo
- Descale, rinse, screw back on by hand
When to call a professional
- If hardly any water comes out despite a clean aerator
- If the thread is damaged
- If the tap itself drips
Emergency 24/7: +41 58 510 76 24
Plumbing glossary: Tap aerator (Perlator)
This page in German: /blog/perlator-reinigen
